مشكلة الهاردات التوشيبا -pc3000 udma busy
<!--[if gte mso 9]><xml> <o:OfficeDocumentSettings> <o:AllowPNG/> </o:OfficeDocumentSettings> </xml><![endif]--> <table class="MsoNormalTable" style="width:100.0%;mso-cellspacing:0cm;mso-yfti-tbllook:1184;mso-padding-alt: 0cm 0cm 0cm 0cm" border="0" cellpadding="0" cellspacing="0" width="100%"> <tbody><tr style="mso-yfti-irow:0;mso-yfti-firstrow:yes"> <td style="padding:0cm 0cm 0cm 0cm" valign="top">
[FONT="]Toshiba BUSY[/FONT]
</td> </tr> <tr style="mso-yfti-irow:1;mso-yfti-lastrow:yes"> <td style="padding:0cm 0cm 0cm 0cm"> [FONT="]Problem:[/FONT][FONT="][/FONT]
[FONT="]After turn on power supply drive is ready, but after any actions stay BUSY. Without drive ID and capacity.[/FONT]
[FONT="]Maybe problem called by damaging G-list or SMART.[/FONT]
[FONT="]Try next steps to access Service Area:[/FONT]
- [FONT="]Turn off power supply and isolate Heads contacts on PCB.[/FONT]
- [FONT="]Turn on power supply. Now disk BUSY.[/FONT]
- [FONT="]Perform Soft reset (F7), if it will not helped then perform Hard reset (F8).[/FONT]
- [FONT="]Disk is ready. Then perform Sleep (Standby). Tools -> HDD -> Standby[/FONT]
- [FONT="]Remove isolator from Heads contacts. Set PCB back and try to read Drive ID.[/FONT]
- [FONT="]Re-launch utility. This picture show problem with damaged G-list. [/FONT]
- [FONT="]Create backup. Then clear G-list.[/FONT]
- [FONT="]Try to read sectors. If it contain a useless info try to swith off Techno mode and try to read again.[/FONT]